Laserfiche WebLink
<br />. ILE No. 902 08/13 '96 09:54 ID:STV <br /> <br />6124540578 <br /> <br />PAGE 5 <br /> <br />Tension wire <br /> <br />Galvanized or aluminum coated coil <br />spring wire, 7 gauge. <br /> <br />Padlocks <br /> <br />Schlage 45-102, 26D with two keys: one <br />padlock for each gate latch, all keyed <br />alike, according to Sprint Spectrum <br />requirements. <br /> <br />Padlocks <br /> <br />Furnished by Contractor. <br /> <br />2E.5 SWING GA rES. Gates shall be swing type, hinged to swing J80 degrees from <br />closed to open, complete w: th frames, latches. StOps, keepers, hinges, fabric, braces, <br />padlocks, and three strands I)f barbed wire. Gate leaves, except those on walk-through <br />gates. shall have intermediate members and diagonal truss rods as required for rigid <br />construction and shall be free from sag or twist. Gates shall be fitted with vertical <br />extension arms or shall have frame end members extended to carry barbed wire, Joints <br />between frame members shall be made by welding or by means of heavy fittings and shall be <br />rigid and watertight. Truss rods shall be not less than 3/8 inch diameter. Gate fabric shall <br />be same as fence fabric and $hall be attached to frame ends by stretcher bars. bolt hooks. or <br />other mechanical means, <br /> <br />Hinges shall be hea\l)' pattern with large bearing surfaces and shall not twist or turn under <br />the action of the gate, <br /> <br />Latches shall be plunger bar type, full gate height, and arranged to engage !tie gate stop. <br />except single gates less than 10 feet wide may be provided with a forked latch. Latches <br />shall be arranged for padlocking with the padlock acces~ible from both sides of the gate, <br /> <br />Stops shaIl consist ofa road'Nay plate with anchor set in concrete and arranged to engage. <br />the plunger, <br /> <br />Keepers shall consist of mec1anicaJ devices for securing and supporting the free end of the <br />gates when in the full open p,:)sition. Keepers shall be mounted on 2-7/8 inch outside <br />diameter pipe posts filled wit.h concrete and set in concrete foundations. <br /> <br />Gates shall be installed so thilt they cannot be removed without disassembly of the <br />hardware. Hardware attachm~nt bolts shall be peened so that removal will be difficult. <br /> <br />2E.6 ***FENCE CONSur~ICTIQN. The installed fence shall conform to the alignment <br />and finish grade indicated. Unless otherwise indicated or specified, all posts shall be plumb <br />and spaced approximately 10 feet apart, <br /> <br />FCS 28660 GEN CONST 71.0800 <br />052496 <br />2E-3 <br />