Laserfiche WebLink
city of <br /> NEW <br /> BRIGH M\ <br /> the city that works for you <br /> interoffice <br /> MEMORANDUM <br /> to: Janice Gundlach, City Planner <br /> from: Craig Schlichting, Senior Engineering Supervisor <br /> subject: API Training Center and Offices <br /> date: July 8, 2014 <br /> The Engineering Department has reviewed the site plan and preliminary grading & utility plans for The <br /> Enclave and we offer the following comments: <br /> Streets/Trails- <br /> 1. Additional spot elevations are required at the driveway entrance to insure proper drainage. <br /> 2. Additional spot elevations are required on the walk along the ROW and at the pedestrian ramps to <br /> verify ADA compliance and proper drainage. <br /> 3. A note shall be added to the plans indicating that the contractor must contact Mark Herrick in the <br /> Engineering Department at 651-638-2054 for inspection of all street and utility work. <br /> 4. An irrigation plan should be prepared to address sprinkling needs. <br /> 5. A detail for proposed pylons need to be added to the plans. I believe that this was sent as part of a <br /> larger package to the owners Engineer. <br /> Storm Sewer-Grading <br /> 1. The fill quantity(anticipated import—7,500 CY)needs to be quantified on the plans. The haul route of <br /> the import should be discussed to eliminate/limit impacts to existing streets/utilities. <br /> 2. Drainage calculations/areas including discharge rates, HWL's and storm sewer sizing should be <br /> included with future submittals for our review. With each drainage area we would like to see the hard <br /> surface area to include the maximum buildout(with proof of parking). <br /> 3. A permit will be required from the Rice Creek Watershed District. <br /> 4. If a cross gutter is required to properly drain the intersection, it needs to be shown on the plans(it is <br /> currently unknown without detailed intersection drawings/elevations). <br /> 5. Site storm sewer will connect into an existing storm sewer near the entrance. Please provide a shop <br /> drawing for SK-01 and indicate the proposed casting on the plan. <br />