0758 - Laserfiche WebLink

Home Browse Search

Article 3. Commercial and Industrial Zoned Districts Sec. t{070. Commercial Zoning Districts, B -I and B-2. (1) pund Sign. A single ground sign is permitted per street frontage. Such sign shall not exceed 36 squat feet in area, shall not exceed twenty feet in height and shall be set back ten feet from any street right -If -way. On each street side of less than 100 feet, a single ground sign not exceeding twelve square feet ii il area shall be permitted. i (2) ll Sign. A single wall sign is permitted per street frontage. Such sign shall not exceed thirty perce Pit of the signable area or 200 square feet in area, whichever is less. Signable area is an area of a build iig free of windows or doors. The maximum size of the selected signable area is determined by calcu ting the number of square feet that are enclosed by an imaginary rectangle around this area. (3) ltiple Occupancy Buildings. See regulations under Section 9-110. (4) B #lding Sides not Abutting a Street. See regulations under Section 9-120. (5) -Street Parking Sign. A wall sign may be displayed on the side or rear of a building adjacent to an off -s et parking area if the off-street parking area has five or more parking stalls and such stalls are on the prfmises. In no case shall the size of such sign be larger than the size of a permitted wall sign on the front 4f the building. (6) Fctronic and/or Dynamic Signs. A single electronic and/or dynamic sign per lot is permitted so long such sign conforms to the ground and wall sign regulations of this Section and the following addit 4onal operating conditions: A. Message changes may not occur any more frequent than once per 8 seconds. Excluded from this standard are time, temperature, and fuel price signs. B. 35 feet of separation from another sign considered dynamic. C. Luminance levels must comply with the following: 5,000 nits — 7,000 nits in the daytime hours and not more than 500 nits in the nighttime hours. D. The sign manufacturer must submit certification at the time of Sign Permit issuance that the sign has the mechanical capabilities to control luminance at the levels noted in C above. In no instance shall the sign have the mechanical capabilities to exceed 7,000 nits. (7) P+manent Window Sign. Permanent window signs may not exceed 25 percent of total area of the wind in which they are displayed. (8) 7,,tnporary Window Sign. The total area of window signs (both permanent and temporary) may not excei fifty percent of the area of the window in which they are displayed. (9) porary sign. A temporary sign is permitted as regulated in Section 9-046. (Ord. No. 534, 9-24- 85; d. No. 620, 2-13-96; Code of 2001; Ord. No. 758, 3-11-08) See. t080. Commercial Zoning Districts, B-3. (1)�ound Sign. A single ground sign is permitted per street frontage. Such sign shall not exceed 64 squa@ feet in area, shall not exceed twenty feet in height and shall be set back ten feet from any street Page 13 of 17